An Analog-to-Digital Converter (ADC) does exactly what the name implies: it converts an analog electrical signal to a digital representation. Specifically, the analog signal is a continuous-time continuous-amplitude signal, and the digital signal representation produced by the typical ADC is a sequence of discrete-time discrete-amplitude samples. The process of conversion from a high-resolution signal to a low-resolution signal is also known as quantization.

The two main types of ADCs are oversampling converters and Nyquist-rate converters, and there are several architectures for these. In most cases, there is some form of uniform quantization being performed on a high-resolution signal, in order to represent it in terms of a finite set of quantization levels. The error that results from quantization is referred to as *quantization error*. The spectral representation of random quantization error is known as *quantization noise*.

An ADC requires a clock signal to synchronize the instances when the analog signal is sampled. The clock frequency is referred to as the sampling rate, i.e. the rate at which samples are taken, and can be denoted fs. It is important that the clock have little or no clock jitter, which creates uncertainty in the sampling instant, and hence increases the quantization error.

An ADC also typically requires a reference voltage, denoted by *V*_{REF}, which determines the valid voltage range over which the analog input signal can be converted. The input range of an ADC that only operates on positive voltages would go from zero volts, or circuit ground, to *V*_{REF}. If the analog signal takes on values outside this voltage range, a well-designed input circuit will non-catastrophically limit the ADC to either minimum or maximum voltage, depending on the input signal. As expected, this would produce either a minimum or maximum digital value at the output.

The most common representation used for the digital samples produced by an ADC is a string of binary digits (or bits), where *00..0* represents the smallest analog input, and *11..1* represents the largest. These are sometimes referred to as *ADC output codes*. An N-bit binary number can represent at most *2*^{N} unique levels, and therefore, an N-bit ADC can produce *2*^{N} unique codes.

The quantization step or width of each ADC code can be denoted *q*, where *q* = *V*_{REF}/*2*^{N}. The nominal ADC code width is expected to be equal to a single *LSB* (least-significant bit), which is the right-most bit in a binary word representation. When the code width is normalized to *V*_{REF}, *q* = 1/*2*^{N}.

In the figure above, an example of a 3-bit ADC encoder transfer function is shown on the left, relating the digital output to the analog input. The encoder transfer function is arranged so that any input signal less than *q*/2 produces the smallest digital code, *000*, input signals between *q*/2 and 3*q*/2 produce the next digital code *001*, and so on. Alternate arrangements are possible, depending on the specific application requirements of the ADC.

The quantization error resulting from using this encoder transfer function is shown in the figure above on the right, and in this case, it takes values over the interval [-*q*/2,+*q*/2]. This assumes that the ADC input is appropriately limited and the digital output code is saturated when the input signal goes outside the operating range of the ADC.

The figure below shows the result when a full-scale sine wave is provided at the input to an ADC with this encoder transfer function.

It should be apparent that quantization is a highly non-linear process, and this makes it very difficult to perform an exact analysis of an otherwise linear system. In order to use classical linear analysis, it is necessary to derive a suitable linearized model of the quantizer, and this will be covered in a future post.

**Copyright © 2008 – 2012 Waqas Akram. All Rights Reserved.**

on April 27, 2012 at 2:57 am |Sampling and zero-order holds « Dwell Angle[…] waveform through an analog-to-digital converter (ADC) as a stair-step response (including on this blog). This representation is not strictly correct because it presumes that signals produced at the […]